Re: [hatari-devel] NatFeats on Windows (was: Preparing for next release 2.4)

[Paweł Góralski <pgoralski@xxxxxxxxxxxx>]

02), you don't see any Natfeats logging from your application in the
separate window, right?

Yes. I've sent two files with output one from separate window, second 
copied from cmd window. Original binary didn't output anything related 
to natfeats when Hatari opened separate console window.

I'm not very sure, but I think that I've had similar natfeats behaviour 
on Arm (on Debian/Bullseye 64bit, raspberry pi 4 and custom build), but 
I have to recheck it once again to be 100% sure (I don't have hardware 
at hand atm).

Regards,

PG

On 03.07.2022 17:02, Christian Zietz wrote:
> Paweł Góralski schrieb:
>
> > As a follow up to my previous mail I can confirm that natfeats logging
> > started to work in my application too, when I've used modified binary
> > and launched hatari from cmd. But I'm using only logging right now, no
> > other features.
>
> That's frankly a bit weird. What this change does: It changes the
> so-called "subsystem" in the PE executable header from GUI (02) to
> Console (03). This means that the standard handles are directed to the
> console from where you launched Hatari. Otherwise, there is no console
> attached and, as you know, you therefore need the "-W" switch to open a
> separate console window.
>
> But for me Natfeats output and other Natfeats calls work in either case.
> I don't recall: If you use the original binary (i.e, subsystem set to
>
> Regards
> Christian
> --
> Christian Zietz  -  CHZ-Soft  -  czietz@xxxxxxx
> WWW: https://www.chzsoft.de/
> PGP/GnuPG-Key-ID: 0x52CB97F66DA025CA / 0x6DA025CA