| Re: [hatari-devel] 24 bits addressing issue |
[ Thread Index |
Date Index
| More lists.tuxfamily.org/hatari-devel Archives
]
Hi,
On 12/11/20 12:35 AM, Uwe Seimet wrote:
Something appears to be wrong with the 24 bits addressing mode. It's
disabled in my (TT) setup. When I enable it Hatari reports that it is going
to use 32 bit addressing, which my cause problems. This messages appears to
be wrong, because I'm just doing to oppsite, namely enabling 24 bits
addressing.
When I now reset Hatari and enter the settings again, the 24 bits addressing
setting is disabled even though I enabled it before the reset.
Everything is fine. Hatari needs to use 32-bit
addressing when TT-RAM is used, and it's telling
that it automatically switched (back) to that.
Would the message be clearer if it would state:
Automatically enabling 32-addressing to support TT-RAM.
instead of:
Enabling 32-addressing for TT-RAM access.
?
As to what's shown on console, I think this
message should be WARNING, not an ERROR.
- Eero