[qet] Loosing info by copy and paste

Dear Laurent,

there is a way to do a copy and paste of a list of connector pins without loose the label number and other information ?

Thank you

Marco

MARCO NACCINI

GORIZIANE GROUP S.P.A.

Engineering & Construction

Project Engineer

Via Aquileia, 7
34070 Villesse GO
Italia

+39 048191511

+39 344 1732988

marco.naccini@xxxxxxxxxxxx

This message contains personal data according to Legislative Decree 196/2003, the consultation, processing, modification, store, diffusion and use of which in any procedure, way and extent on behalf of unauthorized subjects, according to not allowed manners or to purposes different from the agreed ones amounts to illegitimate treatment and source of grave penal, civil and administrative responsibility. In case of wrong receipt of this message, it is kindly asked to advise the sender immediately and to get rid of its contents

-----Original Message-----
From: laurent Trinques <scorpio@xxxxxxxxxxxxxxxx>
Sent: martedì 17 marzo 2020 15:04
To: qet@xxxxxxxxxxxxxxxxxxx
Cc: MARCO NACCINI <marco.naccini@xxxxxxxxxxxx>
Subject: Re: [qet] Replkace in XML

Le mardi 17 mars 2020, 13:08:16 CET MARCO NACCINI a écrit :
> Hello I'm trying to use QElectroTech.
>
> It is useful but I would like to ask some tricks.
>
> I done a good drawing but I put some hundred of male pins but I
> mistake a I would like to convert all of them to be female type.
>
> I'm tryng to operate on xml file and I found that, apparently, the
> only difference between male and female pins is this part:
>
> embed://import/10_electric/10_allpole/140_connectors&plugs/01_conn
> ectors
> _pins/connecteur_m.elmt">
>
> instead then
>
> embed://import/10_electric/10_allpole/140_connectors&plugs/01_conn
> ectors
> _pins/connecteur_f.elmt">
>
> Bus when I exchange one with the other I obtain that in QElectroTech
> the pin disapper.
>
> Do you have an idea how can I use xml to do it ?
>
> In the attachment the file qet.
>
> Can you help me ?
>
> Thank you
>
>
> Marco
>
> GORIZIANE GROUP S.P.A.
> Engineering & Construction
> Project Engineer
> Via Aquileia, 7
> 34070 Villesse GO
> Italia
> +39 048191511
> +39 344 1732988
> marco.naccini@xxxxxxxxxxxx
> This message contains personal data according to Legislative Decree
> 196/2003, the consultation, processing, modification, store, diffusion
> and use of which in any procedure, way and extent on behalf of
> unauthorized subjects, according to not allowed manners or to purposes
> different from the agreed ones amounts to illegitimate treatment and
> source of grave penal, civil and administrative responsibility. In
> case of wrong receipt of this message, it is kindly asked to advise
> the sender immediately and to get rid of its contents

Hello Marco,

see attached corrected dawning.
In this case, just edit your male pins element put in your diagram make change, save element edited, save to another name (for backup)and launch this new project.

Best regards,
Laurent