Re: [crisos] Problem with usbserial |
[ Thread Index |
Date Index
| More lists.tuxfamily.org/crisos Archives
]
- To: crisos@xxxxxxxxxxxxxxxxxxx
- Subject: Re: [crisos] Problem with usbserial
- From: Claudio <claudyus84@xxxxxxxxx>
- Date: Sat, 4 Apr 2009 10:35:07 +0200
- Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=gamma; h=domainkey-signature:mime-version:received:in-reply-to:references :date:message-id:subject:from:to:content-type :content-transfer-encoding; bh=IRQyLR/LvCFsyKOp494h16TO7PMLb+9B6z5wcuWEZps=; b=RTyOeCbI6Y64A4HafjzWkdAik7b1xB9eozxIZ4/T01lfr/PK1RqDfMK2P7PzvI/y3E F51oDiTNMscYRANhiphlbwAApPqSkIcnpmJr6V1ymhJlCSqWK/cGDHx1vzsonT1cHyno IOeWRw+3fNwgTZRO+8e2jMmc1oZgAILEt1DJM=
- Domainkey-signature: a=rsa-sha1; c=nofws; d=gmail.com; s=gamma; h=mime-version:in-reply-to:references:date:message-id:subject:from:to :content-type:content-transfer-encoding; b=FZKysDIViF0ZMuuwQnFvsulb6b7TYpPj8dC6cIA39JzFtxNT4Vg8KDOZKY79eGW5Tl 0CuN73qqfuIoB9JIo0ueLflebtUlXR8bXx8nChDFIzglQtTiiujbeQsZPvUGUqujYCFG TjDwVP5Poe4wocSM30KAENfCfkUi4STRTMHTk=
Hi Zoni,
for this driver problems you should directly contact axis on
mailinglist: http://www.axis.com/techsup/dev/support_info.htm
Hence I will be very happy to integrate any improvement inside openwrt.
2009/4/2 J S <sippis1976@xxxxxxxxx>:
> Hi,
>
> just wondering if anyone would have a solution for the following problem:
>
> In our Darwin/Foxboard project, the both USB ports on Foxboard are/can be
> equipped with a device that uses usbserial driver. In certain case we should
> make a HW-reset for one of these devices (power down/up); the other device
> shouldn't be affected on this. We already tried disabling / enabling a
> either of the ports works as should; also if the other device is used by
> i.e. usb-storage, the HW reset for one port works OK.
>
> But, if both ports have an active usbserial device, this causes kernel
> panic. In hc_crisv10.c there is a comment: "Two devices responded to a
> transaction request. Must be resolved by software. FIXME: Reset ports?". Ok,
> resetting the ports (or even reloading usbserial) would be a partial fix for
> our project, but would it be possible to preserve the other port?
>
> Regards, Zoni
>
---
CrisOs mailing list
Official multi-language http://www.crisos.org/ mailing list
For unsubscribe send empty mail to: crisos-request@xxxxxxxxxxxxxxxxxxx with subject unsubscribe.