Re: [crisos] Problems flashing

I use a cross cable and eth0

On Sat, Oct 18, 2008 at 10:14 AM, Claudio <claudyus84@xxxxxxxxx> wrote:

Your foxboard and pc should be connected to the same wired lan.
You should avoid to use hub/router between your pc and fox!

The simplest solution is to use a crossed cable lan.

Also note that boot_linux used eth0 as default

2008/10/15 Bram De Smet <bramtjah@xxxxxxxxx>:

> Hi,
> I got my board and am trying to flash it with CrisOS.
> I disconnected the board, applied the jumper, started the command and
> powered up the board.
> This is what I get in my terminal:
> Staring boot...
> We're doing a flash write, this may take up to a few minutes...
> Device ID = 0x0000ffe0
> This bootleader was built by root on Wed 16 21:31:41 CEST 2007.
> Checksum of bootloader is 0x000a0a94
> Waitinf for load info.
> Checksum of file is 0x000002d9
> Got load info.
> PACKET_INFO
> 0x00000000
> 0x0001c120
> I waited for a long time, but nothing happens.
> After a Ctrl-C and a reboot of the board, I got shh-ed in and found the same
> linux it came with...
> Am I doing anything wrong?
> Thanks
> Ciao
> Bram

--
Claudio
User linux #415284
http://www.crisos.org/ - Cris linux distribution

---
CrisOs mailing list
Official multi-language http://www.crisos.org/ mailing list

For unsubscribe send empty mail to: crisos-request@xxxxxxxxxxxxxxxxxxx with subject unsubscribe.